Alpine INA-W910R Owner's Manual page 95

How to use a Seal
If A is used for installation:
Affix the seal so that mounting holes B and C are covered.
If B is used for installation:
Affix the seal so that mounting holes A and C are covered.
If C is used for installation:
Affix the seal so that the mounting holes A and B are covered.
Installing the Face Plate
2
* If A is used, the supplied face plate may be mounted.
If B is used, the face plate must be modified before installing it.
To modify the face plate, consult your Alpine dealer.
If C is used, the face plate cannot be mounted. Consult your Alpine
dealer.
4
Hex Nut (M5)
Metal
Mounting
Strap
Ground Lead
Chassis
Screw
2
*
Bolt Stud
1
*
This unit
When your vehicle has the Bracket, mount the long
hex bolt onto the rear panel of the INA-W910R and
put the Rubber Cap on the hex bolt. If your vehicle
does not have the Mounting Support, reinforce the
head unit with the metal mounting strap (not
supplied). Secure the ground lead of the unit to a
clean metal spot using a screw (*
to the vehicle's chassis. Connect all the leads of the
INA-W910R according to details described in the
CONNECTION section.
2
• For the screw marked "* ", use an appropriate screw for the chosen
mounting location.
5
Slide the INA-W910R into the dashboard until it
clicks. This ensures that the unit is properly locked
and will not accidentally come out from the
dashboard.
Removal
1. Insert the bracket keys into the unit, along the guides
on either side. The unit can now be removed from the
mounting sleeve.
This unit
2. Pull the unit out, keeping it unlocked as you do so.
<JAPANESE CAR>
Take the face plate off, and secure the ground lead of the unit to
a clean metal spot using a screw (*) already attached to the
car's chassis.
Attach the Original Mounting Bracket to each side of the
INA-W910R, using the screws supplied with INA-W910R.
Ground Lead
*
Mounting
Bracket
Chassis
1
) already attached
Bracket keys
(Included)
Screws (M5 × 8) (Included)
Face Plate (Included)
95
-EN