Maintenance; Xii. Maintenance; Lubrication; Miscellaneous - Grizzly G1016 Instruction Manual

XII. Maintenance

Since the moving parts on this machine run
on shielded ball bearings, you will find that
there is very little in the line of routine mainte-
nance outside of cleaning (See Section XI).
However, "little maintenance" does not imply
"no maintenance." This section will cover a
few simple but crucial steps for the proper
maintenance of your bandsaw.
A. Lubrication
Shielded and pre-lubricated ball bearings
require no extra lubrication for the life of the
bearings. All bearings are standard sizes. If
they wear out, replacements can be easily
purchased from our parts department or bear-
ing supply stores.
As for other items on this machine, such as
adjustment controls, an occasional "shot" of
light oil is just about all that is necessary.
Before applying, however, wipe off any debris
with a clean cloth or towel and spray on the
lubricant. Ensure that oil does not get on the
pulleys or V-Belts because it could cause belt
deterioration and slipping. Wipe off any spray
that gets on the blade, meat grinder, or any
stainless steel cutting surfaces.
- 20 -
Hunters Meat Cutting
Bandsaw
B. Miscellaneous
Always be aware of the condition of your
bandsaw before using it. Routinely check the
condition of the following items and repair or
replace as necessary.
1. Loose mounting bolts.
2. Worn switch.
3. Worn or damaged blade.
4. Worn or damaged support bearings or
guide blocks.
5. Worn or damaged V-Belt.
6. Any other condition that may affect safe
operation of this machine.
End of Section