General Maintenance - Spirit XT485 Owner's Manual

GENERAL MAINTENANCE

BELT/DECK
Your treadmill uses a very high-efficient low-friction deck. Performance is maximized
when the deck is kept as clean as possible. Use a soft, damp cloth, or paper towel, wipe
the edge of the belt and the area between the belt edge and the frame. Also reach as far
as practical directly under the belt edge. This should be done once a month to extend
belt and deck life. A mild soap and water solution along with a nylon scrub brush will
clean the top of the textured belt. Allow to dry before using.
BELT/DECK
This occurs during normal break-in or until the belt stabilizes. Sometimes the black dust
from the belt will appear on the floor behind the treadmill, this is normal.
GENERAL CLEANING
Dirt, dust, and pet hair can block air inlets and accumulate on the running belt. Please
vacuum underneath your treadmill on a monthly basis to prevent excess build-up of dirt
that can get sucked up and get into the inner workings under the motor cover. Once a
year, you should remove the black motor hood and vacuum out dirt that may accumulate.
UNPLUG POWER CORD BEFORE THIS TASK.
BELT ADJUSTMENTS
Tread-belt Tension Adjustment - Belt tension is not critical for most users. It is very
important though for joggers and runners in order to provide a smooth, steady running
surface. Adjustment must be made from the rear roller with the 6 mm Allen wrench
provided in the parts package. The adjustment bolts are located at the end of the step
rails as shown in the diagram below.
Tighten the rear roller only enough to prevent
slippage at the front roller. Turn the tread-belt
tension adjusting bolts 1/4 turn each and inspect
for proper tension by walking on the
belt and making sure it is not slipping or
hesitating with each step. When an adjustment
is made to the belt tension, you must be sure to turn the bolts on both sides evenly or the
belt could start tracking to one side instead of running in the middle of the deck.
DO NOT OVERTIGHTEN – Over tightening will cause belt damage and premature
bearing failure. If you tighten the belt a lot and it still slips, the problem could actually be
the drive belt - located under the motor cover - that connects the motor to the front roller.
If that belt is loose it feels similar to the walking belt being loose. Tightening the motor
belt should be done by a trained service person.
29