Table of Contents
Advertisement
Lubrication
The bearings used in the motor, the wheels and
the blade guides are shielded and pre-lubricated
ball bearings. These require no lubrication for
the life of the bearings. All bearings are standard
sizes and replacements can be purchased from
our parts department or bearing supply store.
The rod on which the saw bow pivots needs
an occasional shot of light oil to keep it moving
smoothly.
The gear box should not need changing unless
the oil becomes contaminated or leaks. To check
the oil, lower the saw bow down all the way and
wait a few minutes for the oil to drain down. Open
the oil cap on top of the gearbox. The gear case
is full when the oil is up to the bottom of the filler
hole. Use 90W gear oil if it becomes necessary to
change or add to the oil.
Coolant System
The coolant system must be properly filled with
the proper mix of coolant and water in accor-
dance with the coolant manufacturer's specifi-
cations. The coolant will need to be replaced
periodically as the bandsaw is used more. Some
coolant types also breakdown over time, or need
additives to reduce the growth of bacteria or fun-
gus in the solution.
There is a filter in the bottom of the coolant pump
which will need periodic cleaning or replacement.
Any time coolant flow does not seem sufficient,
check the coolant sump for level, and check the
pump filter.
G1011 7" x 12'' Bandsaw
Miscellaneous
Always be aware of the condition of your bandsaw
before using it. Routinely check the condition of
the following items and repair or replace as nec-
essary.
1. Worn or damaged blade.
2. Worn switches.
3. Loose mounting bolts.
4. Worn or damaged support bearings or
guide bearings.
-21-
Advertisement
Table of Contents
