Clean The Ink Cartridges; Replace Consumables; Replace The Fan Filter - Rimage 2000i User Manual

Rimage 2000i™ User Guide
7. Slide the left side panel into place.
8. Position the back panel on the system.
9. Install and tighten the Torx T10 screws (Qty. 6) to secure the back panel.
10. Connect the cables at the back of the system.
•
Power cord.
•
USB cable
11. Power on the Rimage 2000i.
12. Press the recorder buttons to close the recorder trays.

Clean the Ink Cartridges

This functionality allows you to clean the ink cartridge nozzles. The nozzles may become clogged from dried ink, causing poor
print quality.
1. Access Printing Preferences. Refer to page 15.
2. Select the Servicentab.
3. On the Service tab, select Service ToolBox. The Service ToolBox dialog box opens.
4. Select Clean Cartridges. The Cleaning Cartridges window opens.
5. Select Light to clean the ink cartridge nozzles with the least amount of ink. When the cleaning is complete, a message
displays in the status field at the bottom of the Cleaning Cartridges window.

Note: Print a test disc after you clean the ink cartridge nozzles. If print quality is still poor, repeat step 1 - step 5,
selecting Medium or Heavy in step 5.
Select OK. The Cleaning Cartridges window closes.
6.
7. Select OK. The Rimage Service ToolBox dialog box closes.
8. Select OK. The Preferences window closes.

Replace Consumables

This section provides information about replacing the fan filter and ink cartridges in the Rimage 2000i.

Replace the Fan Filter

The fan filter is a consumable item. You must change the fan filter every month. Use the following procedure to change the fan
filter.
1. On the back of the Rimage 2000i, firmly grasp a corner of
the fan filter retainer.
2. Gently pull the fan filter retainer away from the back of
the Rimage 2000i.
3. Remove the fan filter.
4. Place the new fan filter in the fan filter retainer.
5. Firmly press the fan filter retainer into the slots on the
back of the Rimage 2000i until it snaps into place.
24 100763_M