Riving Knife - Grizzly G0460/G0461 Owner's Manual

15. Check if the bottom of the rip fence rests on
the surface of the table.
Note: The rip fence will scratch the table if
the ride height is not adjusted correctly.
— If the rip fence DOES NOT rest on the
table, then the fence is correctly adjusted.
— If the rip fence rests on the table, loosen
the hex nut shown in Figure 32 and rotate
the hex bolt to raise the roller. Tighten the
hex nut to lock the height.
Figure 32. Rip fence height adjustment.
G0460/G0461 12" Sliding Table Saw

Riving Knife

To install the riving knife:
1.
DISCONNECT SAW FROM POWER!
2.
Loosen the riving knife center bolt, slide the
riving knife between the plates as shown in
Figure 33, and slightly tighten.
Figure 33. Installing the riving knife.
3.
Position the riving knife about 3mm or
away from the nearest carbide tooth on the
main blade. Note: For a quick gauge, use the
3mm hex wrench to find the correct spacing
between the blade and the riving knife, as
shown in Figure 34.
Figure 34. Adjusting the riving knife.
4.
Tighten the center bolt to secure the riving
knife in position.
Riving Knife
⁄ "
1
8
-25-