Related Manuals for Hunter 90398
Summary of Contents for Hunter 90398
- Page 1 16” Outdoor Stand Fan 18” Outdoor Stand Fan 18” Outdoor Stand Fan with Misting Feature Owner’s Manual Model 90398 Form# 47009-01 20120216 ©2012 Hunter Fan Co.
-
Page 2: Table Of Contents
TABLE OF CONTENTS Introduction ..........3 Safety and Warnings . -
Page 3: Introduction
INTRODUCTION Thank you for choosing the Hunter Outdoor Stand Fan with Misting Feature. Using your Hunter Fan will provide a soothing, cooling mist to any outdoor environment. For optimal cooling effects, the misting fan should be run with outdoor temperatures above 85 F and humidity levels below 85%. -
Page 4: Unpacking
SAFETY AND WARNINGS (CONTINUED) To disconnect, grip plug and pull from wall outlet. NEVER pull directly on cord. This product is intended for residential use only and not for commercial or industrial use. DO NOT operate fan in the presence of explosive and/or flammable fumes, or freezing temperatures. This appliance has a grounded three-prong plug and is suitable for grounded receptacle use only. -
Page 5: Parts List
Motor Housing Tilt Adjustment Knob Motor Housing Pole Power Cord GFCI Motor Housing Screws Height Adjustment Knob Motor Housing Pole Screw Internal Pole External Pole Cord Clip Base Weight Large Washer L Bolt Valve Misting Line ©2012 Hunter Fan Co. -
Page 6: Base Assembly
BASE ASSEMBLY Remove the L Bolt (X) and Large Washer (W) from the pole assembly. Insert the External Pole (S) into the Base (U). Figure 1. With Base and pole assembly on its side, insert the L Bolt through the Large Washer and then through the Weight (V) and the Base. -
Page 7: Misting Ring Installation
Install the Blade Cap (C) by hand-tightening in a counter clockwise direction. Place the Front Grill (B) against the Rear Grill (E) so that the Hunter logo faces right side up and push together until the tabs at the top and bottom of the grills hold them together. - Page 8 OPERATION AND ADJUSTMENTS (CONTINUED) Place the fan on a level surface. Plug the GFCI plug into a standard 120-volt AC 3-Prong wall outlet. • Attach the Valve (Y) onto a standard outdoor hose. Turn your water on at the spigot and use the lever (yy) on the Valve to turn water on and off.
-
Page 9: Maintenance
MAINTENANCE Warning! Before cleaning your Hunter fan, turn the unit off, unplug it, and disconnect the water hose from the misting valve. Never use harmful or abrasive chemicals and ALWAYS unplug the fan. Fan Maintenance: The fan body and grill can be cleaned with a slightly damp cloth. A mild dish detergent can be used if necessary. When cleaning the fan, ensure you DO NOT let excess water drip into the base of the motor where the controls are or into the motor compartment in the grill. -
Page 10: Technical Support
TROUBLESHOOTING (CONTINUED) Problem Fan will not run. Solution • Ensure the fan is plugged in. Check the GFCI on the fan’s plug. If the window is black the GFCI has been tripped, it needs to be reset. Press the “Reset” button on the plug. If the GFCI window is orange then the circuit is active and does not need to be reset. Problem Fan will not oscillate. -
Page 11: Warranty
Portable fan: If your Hunter Portable Fan motor fails at any time within one year after the date of sale to you due to a defect in material or workmanship, labor to repair the defect will be provided free of charge at our nearest service center or our Service Department in Memphis, Tennessee. -
Page 12: Products
If we authorize you to ship it to us, you will be responsible for all insurance and freight or other transportation charges to our factory service center. We will return your Hunter Fan freight prepaid. Your portable fan should be properly packed to avoid damage in transit since we will not be responsible for any such damage.