Assembly Hints - Nokia C3-01 Service Manual

10. ASSEMBLY HINTS

1) Attach the KEYMAT to the A-COVER as shown. Note
the location of the pins in the A-COVER.
3) Place the DISPLAY and the DISPLAY CARRIER on the
ENGINE BOARD.
5) Remove the protective film from the DISPLAY.
21
2) Hold the A-COVER as shown and use the SS-93 to
connect the TOUCH PANEL connector to the ENGINE
BOARD. Be careful not to damage any nearby
components.
4) Attach the DISPLAY connector with the SS-93. Be
careful not to damage the connector.
6) Turn the UI/READER MODULE over as shown and
insert the bottom in the B-COVER by pressing it
carefully.
Confidential | Copyright © 2010 Nokia | All rights reserved
Nokia C3-01/C3-01m
RM-640/RM-662
Service Manual Level 1&2
Version 1.0