Oce OP31C Operation Manual page 17

4. Selecting the Printer Settings
G Selecting the serial interface settings
Select "Serial" tab.
1
Use the "L" and "M" cursor keys to select the desired item and then
2
touch the "Change" key. The setting screen for the selected item will
appear.
Baud rate: Sets the Baud Rate 3.
Data Bits: Sets the data bit length 4.
Stop Bits: Sets the stop bit length 5.
Sets the parity 6.
Parity:
Protocol: Sets the protocol 7.
Select the desired setting for each item and then touch the "Close"
3
key. The display will return to the [Interface] screen.
G Selecting the network interface
Select "Network" tab.
1
Use the "L" and "M" cursor keys to select the desired item and then
2
touch the "Change" key. The setting screen for the selected item will
appear.
Turns NetWare On/Off 8 and selects the
Netware:
NetWare Frame type 9.
Turns TCP/IP On/Off 0, DHCP On/Off! and
TCP/IP:
sets the IP address @, Subnet Mask # and
the Gateway address $.
Selects the Ether Talk setting %.
Ether talk:
Option Status Page: Selects the setting for the Network Card Status
Page print out ^.
4-4