Table of Contents
Advertisement
Configuring Windows
for a DW6000 with a
static IP address
Windows 98SEor ME
44
Typical operating system settings
The instructions for configuring a Windows 98SE, ME, 2000, or XP system
with a static IP address vary slightly. Find the appropriate instructions for your
system and follow them.
As you manually configure the client computers you will enter:
• IP Address. You need a valid IP address for each computer. Make sure the
address does not conflict with any other computer connected to the
DW6000. You can obtain the entire list of available addresses for use with
your DW6000 from the Frequently Asked Questions section of the DW6000
System Control Center.
• Subnet Mask. This is the subnet mask assigned to your DW6000. It is
available on the System Information page of the System Control Center.
You would also have written this on the Quick Start Guide during
registration.
• Default Gateway. This is the IP address of the DW6000 and is also available
on the System Information page of the System Control Center. You would
have also written this on the Quick Start Guide at the end of registration.
1. Select
Start→ Settings→ Control Panel
2. Select
. The
Network
tab. See Figure 29.
Configuration
Figure 29: Network dialog with Configuration tab
3. Select the TCP/IP protocol that is bound to the NIC that connects to the
DW6000 and select Properties. In Figure 29 it is
Pro/100VE Network Connection
NIC information. The
See Figure 30.
.
configuration dialog box opens to the
Network
. Your system may display different
box opens to the
TCP/IP Properties
TCP/IP -> Intel (R)
tab.
IP Address
Advertisement
Table of Contents
