Table of Contents
Advertisement
The indicator LED can be disabled with the QR-coded parameter menu or configuration software
(ScannerSetting_2D). In any of the following cases, however, the indicator LED comes on regardless of the current
LED setting.
- When the scanner is being customized with the QR-coded parameter menu (Chapter 12),
- When the scanner receives an LED-ON command (LB, LG or LR) from the host computer (refer to Appendix 2),
- When the configuration software (ScannerSetting_2D) starts up or any setting is newly established,
- When the scanner reads a batch-process QR Code symbol,
- When the parameter values are saved by a PW command (refer to Appendix 2),
- When the scanner is in the scanner entry mode (refer to control command "E" in Appendix 2),
- When a master code is being registered or the registration is completed,
- When any error has occurred during registration of a master code,
- When the scanner has failed to save parameter values specified with the configuration software (ScannerSetting_2D),
QR-coded parameter menu, or control commands,
- When a run-time error has occurred in ADF script, or
- When the trigger switch is pressed when the trigger switch control is disabled.
43
Advertisement
Table of Contents
