Akai S950 Operator's Manual page 61

V-Curve: This allows you to choose from between 8 velocity response curves
to match your own playing technique to the ME35T's triggering
functions.
Page 03 displays further parameters:
These parameters relate to the following functions:
Input: This selects the required audio/pad input channel for editing.
Capture This sets in milliseconds the time before another input signal
time: can retrigger a sample. This is useful for preventing accidental
flamming and retriggering.
Recovery This sets the time in milliseconds of the time it takes for the
time: trigger envelope to settle down.
The next page displays the following parameters:
and these parameters are as follows:
Input: Again, this selects the incoming audio/pad channel for editing.
Gain: This sets the level of the incoming signal which is shown in the
lower half of the display (##at####) as a bargraph meter.
Trig This sets the threshold above which samples on the S950 will be
thresh: triggered.
All these pages' parameters are selected and edited in the usual way. Move
the cursor using the 'cursor 7.and/or <' buttons to the appropriate field and
input data using the CONTROL wheel or the blue keypad.
All parameters set here can be stored to disk along with the samples, program
and MIDI information.
Note: for further information on the hfE35T's parameters, please refer to Its
manual.
>03 #Input #Capture time
1 3 mS
>04 (Input 1 *Gain 50 -(Trig thresh 25
############
49
#Recovery time
20 mS
T