Reinstall Harness And Base - DJG Alpha Omega Owner's Manual

Reinstall Harness and Base

1
2
3
6
5
4
1
3
2
WARNING
!
Failure to reattach the buckle and harness
correctly, can result in serious injury or
death.
Reinstall Harness:
Fit the buckle strap down
through the slot in the
seat. Make sure buckle
faces out.
Slide metal clip under
small tab and push down
on metal clip to lock into
place.
Thread the harness down
through slot on left side of
shell (1), across bottom of
seat (2) and up through
slot on right side (3).
Thread one buckle plate
onto harness from back to
front (4).Thread the
harness retainer (5). Do
the same to the other
harness end. Make sure
the harness is not twisted.
Push harness ends through
upper slots in shell (6).
continued on next page.
46
4
5
WARNING
!
Failure to place harness over the metal bar
of the harness/headrest adjuster in back
can result in serious injury or death.
6
Pull harness through the
back. Make sure the
harness goes OVER the
metal bar of the
harness/headrest adjuster.
Fit loops on harness ends
onto the harness bracket.
Reinstall Base:
Remove bar from base.
Line up shell with base.
Begin with the rounded
end, push bar completely
through slot until it locks
in place. Refer to
"Removal of Seat Base".
47