Table of Contents
Advertisement
4
5
6
7
Push LATCH hook
through the rear-facing
belt path slot.
Pull other end of LATCH
hook between buckle strap
and rear harness slot.
Push LATCH hook
through the other rear-
facing belt path slot.
Put seat pad back over
corners of shell.
Completed threading of
the LATCH system.
28
Rear-Facing Installation with
LATCH: Install in Vehicle
1
2
3
NOTE:
Some "play" from front to back or about an
inch from side to side is acceptable.
If you cannot get the seat to remain tight, do not use
the child restraint in this seating location with this
LATCH system.
Place child restraint rear-
facing in the back seat.
Tuck the top
NOTE:
anchorage strap's hook
under the child restraint.
Fasten one LATCH belt
hook to the anchor in the
vehicle seat located in the
vehicle seat bight. Repeat
for other side of child
restraint. See your vehicle
owner's manual for more
information.
Push down firmly on the
child restraint and pull up
on the loop to tighten belt.
With weakest hand at
belt path, tilt and push
the child restraint
forward and back, and
from side to side. If the
LATCH belts do not
loosen, your child
restraint should be
secure.
29
continued on next page.
Advertisement
Table of Contents
