TracVision M5/M7 User's Guide
Chapter 3 - Settings
DISH Network/ExpressVu Setup
Step 1 - Configure the TracVision System
38
This section explains how to configure the TracVision system for
DISH 1000, DISH 500, or ExpressVu use. For operation instructions
and additional information on DISH modes, refer to "Changing
Channels and Switching Between Satellites (Circular Versions)" on
page 15.
Use the flowchart in Figure 3-11 on page 39 to configure the
TracVision system for DISH Network service. If you need to configure
the system for ExpressVu service, see Figure 3-12 on page 40.
IMPORTANT!
This procedure must be performed while the vessel is docked in
calm water.
NOTE: For your convenience, you can determine your approximate latitude
and longitude using the Position Grids provided in Appendix B on page 75.