TracVision M5/M7 User's Guide
Chapter 3 - Settings
Setting Instant On
36
When Instant On is enabled, the antenna can immediately receive
signals if the vessel has not moved since the antenna was last shut off.
However, if the system is turned off, and then the vessel moves after
last acquiring the satellite via Instant On, the antenna will undergo its
standard initialization process once it is turned back on. This results in
a brief delay.
NOTE: Instant On is disabled by default and is not recommended for DISH
Network and ExpressVu configurations.
Use the flowchart in Figure 3-9 if you wish to enable Instant On, or if
you wish to restore the original setting.
Figure 3-9 Enabling/Disabling Instant On
<Default Display>
Menu
Install Satellite?
Yes
Next Return
Select Next until "Operations
Mode?" is displayed.
Operations Mode?
Yes
Next
Return
Get Antenna Status?
Yes
Next
Return
Control Antenna?
Yes
Next
Return
Select Next until "Set instant
on/off?" is displayed.
Set instant on/off?
Yes
Next
Return
instant mode: ON
On
Enter
Off
Select On or Off as required,
then select Enter.