Programming Your User-Defined Satellite(S) - KVH Industries M5 User Manual

Programming Your User-defined Satellite(s)

To configure a user-defined satellite, you will need to program the
following satellite information into the antenna:
• Satellite name
• Satellite longitudinal position
• Transponder information for all applicable combinations of
polarization/band:
• Frequency
• Symbol rate
• FEC code
• Network ID
• Decoder type
TIP: Linear satellites use the following polarization/band combinations:
vertical high, vertical low, horizontal high, and horizontal low. Circular
satellites use the following polarization/band combinations: right and left.
NOTE: You can find satellite information on the web at
or www.satcodx.com
1. Connect a PC to the maintenance port, as described in
"Connect a PC to the Main Flash Port" on page
Then type the following commands in the
HyperTerminal window.
2. Type HALT then press Enter.
Appendix C - Programming User-defined Satellites
(neither website is affiliated with KVH).
TracVision M5/M7 User's Guide
www.lyngsat.com
79.
81