Table of Contents
Advertisement
5.
Secure the front lower support bracket to the
collector with (2)
5
⁄
16
6.
Place the upper support bracket over the
lower support bracket, and secure with (2)
" flange bolts, as shown in Figure
⁄
"-18 x
⁄
5
1
16
2
9.
Note: The collector attaches to each sup-
port bracket. The inside of the collector is
funnel shaped and directs the air around in
a cyclone motion. Make sure that the inside
taper (funnel) is faced downward and the col-
lector inlet faces toward the collector body.
Lower
Support
Bracket
Figure 9. Mounting collector to brackets.
7.
Slip a loosened hose clamp over each end of
the flex-hose, and attach the ends over the
collector and collector body outlet. Tighten
each hose clamp until snug, as shown in
Figure 10.
Hose Clamp
Figure 10. Attaching flex hose onto collector
body outlet.
G1028Z/G1029Z Dust Collector
"-18 x
1
⁄
" flange bolts.
2
Upper Support Bracket
Collector
Flex Hose
8.
Hook the top loop of the upper filter bag
(fabric) over the support bracket, as shown in
Figure 11.
Figure 11. Attaching upper filter bag.
9.
Tighten the upper bag to the collector using
the clamp shown in Figure 12.
Clamp
Figure 12. Upper collection bag secured.
-15-
Advertisement
Table of Contents
