NAPCO MAGNUM ALERT-725 Operating Manual page 9

Changing or Voiding a Code
Changing any user's code is accomplished
using the foregoing procedure and simply
changing the 4-digit combination. Thus, to
change User 3's code,
1. Set the RUN/LOAD switch to LOAD (lights
flash; Mini-Sounder beeps).
2. Press [S] then [3] then (4 new digits]:
User 3's new code.
3. Return the RUN/LOAD switch to RUN.
Similarly, User 3's code may be voided by
merely not entering a 4-digit combination.
Thus, to void User 3's code,
1. Set the RUN/LOAD switch to LOAD (lights
flash; Mini-Sounder beeps).
2. Press [S] then [3]: User 3's code erased.
3. Return the RUN/LOAD switch to RUN.
Using Your Code to
Arm and Disarm the System
When you enter your personal code at the
keypad, the red ARMED/MEMORY light will
either come on, indicating that the panel is
armed; or go off, indicating that the panel is
disarmed. If you enter the wrong code, you will
not be able to arm or disarm the system and the
light will fail to respond. Wait at least 2 seconds
before attempting to re-enter your code.
In case of an extended power outage, all
personal codes may be erased. Should this
occur, your system will fail to respond to your
personal code. You can then arm or disarm
using your fallback code,
is permanently programmed into your system,
until your personal codes can be restored (see
Your Personal Code
Selecting
Be sure you know your fallback code!
NOTE:
The fallback code will only function
if all personal codes have been lost.
9
a
4-digit code that
8).
on page