Adjusting Volume; Setting The Dimmer Control (Cde-112Ri/Cde-113Bt/Cde-114Bti Only); Radio; Listening To Radio - Alpine CDE-114BTi Owner's Manual

3
Press RESET with a ballpoint pen or similar pointed object.
RESET switch

Adjusting Volume

1
Turn the Rotary encoder until the desired sound is
obtained.
Setting the Dimmer Control (CDE-112Ri/
CDE-113BT/CDE-114BTi only)
1
Press FUNC.SETUP so that the  indicator lights up.
2
Press 6DIMMER repeatedly to select the DIMMER mode.
DIMMER-A (Auto mode)  DIMMER ON  DIMMER OFF 
DIMMER-A
DIMMER-A mode:
Decrease the illumination brightness of the unit with the head
lights of the vehicle ON. This mode is useful if you feel the unit's
backlighting is too bright at night.
DIMMER ON mode:
Keep the illumination brightness of the unit dark.
DIMMER OFF mode:
Keep the illumination brightness of the unit bright.
3
Press FUNC.SETUP to activate the normal mode.
The  indicator goes out.
Notes
• Operate the unit while the  indicator lights up. If no operation is
performed for 10 seconds, the  indicator goes out.
• The function is inoperable when the ILLUMINATI is set to other than
TYPE1 for CDE-112Ri/CDE-113BT, refer to "Changing Lighting
Colour (CDE-112Ri/CDE-113BT only)" on page 17.

Radio

SOURCE/
BAND/TA FUNC./SETUP
TUNE/A.ME
 
The illustrator is for CDE-114BTi.

Listening to Radio

1
Press SOURCE to select TUNER mode.
2
Press BANDTA repeatedly until the desired radio band is
displayed.
F1 (FM1)  F2 (FM2)  F3 (FM3)  MW  LW  F1 (FM1)
3
Press TUNEA.ME to select the tuning mode.
DX SEEK (Distance mode)  SEEK (Local mode)  OFF (Manual
mode)  DX SEEK
Note
• The initial mode is Distance mode.
Distance mode:
Both strong and weak stations will be automatically tuned in
(Automatic Seek Tuning).
Local mode:
Only strong stations will be automatically tuned in (Automatic
Seek Tuning).
Manual mode:
The frequency is manually tuned in steps (Manual tuning).
4
Press  or  to tune in the desired station.
Holding down  or  will change the frequency
continuously.

Presetting Stations Manually

1
While receiving the station that you want to store, press
and hold, for at least 2 seconds, any one of the preset
buttons (1 through 6) into which you wish to store the
station.
The display shows the band, preset number and station
frequency memorised.
Notes
• A total of 30 stations can be stored in the preset memory (6 stations for
each band; FM1, FM2, FM3, MW and LW).
• If you store a station in a preset memory which already has a station,
the current station will be cleared and replaced with the new station.
• If the  indicator is illuminated, turn off the indicator by pressing
FUNC.SETUP, and then you can perform the operation.
Preset buttons
(1 through 6)
7
-EN