Getting Started; Accessory List; Turning Power On And Off; Source Selection - Alpine CDE-114BTi Owner's Manual

Getting Started

SOURCE/ Rotary encoder
FUNC./SETUP

The illustrator is for CDE-114BTi.

Accessory List

• Head Unit ..................................................................................1
• Power Cable ..............................................................................1
• FULL SPEED Connection Cable
(CDE-112Ri/CDE-114BTi only) .................................................1
• Microphone (4 m) (CDE-113BT/CDE-114BTi only) .................1
• Mounting Sleeve ......................................................................1
• Carrying Case............................................................................1
• Rubber Cap ...............................................................................1
• Hex Bolt.....................................................................................1
• Screw (M5 × 8) ..........................................................................4
• Owner's Manual..................................................................1 set

Turning Power On and Off

1
Press SOURCE to turn on the unit.
Note
• The unit can be turned on by pressing any other button except  and
 (Release).
1
Press and hold SOURCE for at least 2 seconds to turn
off the unit.
Note
• The first time power is turned on, the volume will start from level 12.

Source Selection

1
Press SOURCE to change the source.
TUNER  DISC  USB AUDIO  iPod
*4
 TUNER
AUX
Only when the iPhone/iPod is connected and AUX+ SETUP is
set to OFF, refer to "Setting the AUX+ SETUP Mode" on
page 19.
Displayed only when AUX+ SETUP is set to ON, refer to
"Setting the AUX+ SETUP Mode" on page 19.
Only for CDE-111R/CDE-111RM/CDE-112Ri and BT IN is set
to BT ADAPTER. Refer to "BLUETOOTH Setting" on page 17.
Refer to "Using the Front AUX Input Terminal (CDE-112Ri/
CDE-113BT/CDE-114BTi only)" on page 15.
6
-EN
6/DIMMER
*1 *2 *3
 BT AUDIO 
/AUX+

Detaching and Attaching the Front Panel

Detaching

1
Turn off the unit power.
2
Press  (Release) at the lower left side until the front
panel pops out.
3
Grasp the left side of the front panel and pull it out.
Notes
• The front panel may become hot in normal usage (especially the
connector terminals on the back of the front panel). This is not a
malfunction.
• To protect the front panel, place it in the supplied carrying case.
• When detaching the front panel, do not apply excessive force as it may
result in malfunction.

Attaching

1
Insert the right side of the front panel into the main unit.
Align the groove on the front panel with the projections
on the main unit.
2
Push the left side of the front panel until it locks firmly into
the main unit.
Notes
• Before attaching the front panel, make sure that there is no dirt or dust
on the connector terminals and no foreign object between the front
panel and the main unit.
• Attach the front panel carefully, holding the sides of the front panel to
avoid pushing buttons by mistake.

Initial System Start-Up

RESET
1
Turn off the unit power.
2
Remove the detachable front panel.