Advertisement
Now you can setup the system.
Note: Make all initial connections with the system powered off, and, in order to avoid damaging your speakers and
to have too much noise, with mixer main mix volume control completely turned down.
Connect one side of the speaker cable to the left/right power outputs (1/4"TS jacks) of system, and the other
side to the L/R speakers cabinet (1/4"TS jacks), as shown in Fig.5.
Warning! Do not connect additional speakers to the powered output. The system speakers provide the optimal
load for the built-in amplifier. In order to avoid damaging your built-in amplifier, please pay attention to speaker
impedance.
Connecting Microphone, CD players, Tape, MD player (Line sources) etc. to the appropriate MIC/LINE mixer
input connector (XLR/1/4"TRS jacks), as shown in Fig.6.
Now you can turn on the power switch.
Turn up the volume control, use the PFL function to get the proper input level for each mixer channel, then adjust
the main mix level control to manage the output level.
Fig.5
Fig.6
6
Advertisement
