Pitch Bending - American Audio encore2000 User Manual

U P S
SING THE ITCH LIDER
Be sure the pitch function has been activated as described above.
To use the Pitch Slider (5) slide the slider up and down. Down will
increase the pitch and up will decrease the pitch.
A P
DJUSTING THE ITCH
You may change the Pitch Slider (5) operating range at any time. To
change the operating range be sure the pitch function is turned on
as shown in the picture on the right. The pitch percentage can be
changed between +/-4%, +/-8%, +/-16%, & 100%. 4% will allow the
least amount of pitch manipulation and 100% will allow the most
amount of pitch manipulation. To adjust the different ranges, press
the Pitch On/Off Button (6) and tap on the Pitch Range Button (7)
until your desired value is reached as shown in the picture on the
right.
Note: 100% Pitch Adjustment works with CDs only, not MP3 CDs.
13.2 P B
ITCH ENDING
Unlike the Pitch Slider (5) adjustment this function will momentarily increase or decrease a
tracks speed during playback. There are two ways to operate this function with the (-) & (+)
Pitch Bend Buttons (10) or with the Jog Wheel (11). The maximum pitch bend percentage
allowed is +/- 100%. The pitch bend function will work in conjunction with the Pitch Slider (5)
pitch setting. For example, if the Pitch Slider (5) is set to a 2% pitch gain the pitch bending
process will begin at 2% and will continue to the maximum of +/- 100%.
P B B
ITCH END UTTONS
The (+) Pitch Bend Button (10) will increase track playback speed and the (-) Pitch Bend
Button (10) will decrease track playback speed. The extent to which the speed changes are
proportionate to the amount of time the button is pressed. For example, if the (+) Pitch Bend
Button (10) is held down continuously as shown in the picture below on the left, the disc
speed will increase and will continue to increase until it reaches a maximum of 16% speed
gain. When you release the (+) Pitch Bend Button (10) the disc speed will automatically
©American Audio® - www.americanaudio.eu
(5)
S ' (5) R
LIDER S ANGE
Encore2000™ User Manual Page 43