American Audio encore2000 User Manual page 26

Be sure the Master Volume Control (32) is set to level 4.
Set the Channel Fader (26) to level 8.
Begin playback on an audio source connected to the channel you are adjusting.
Use the Gain Control (23) to adjust an average output volume of +4 dB. 5. Repeat this step
for all channels.
(24) Equalizer – All of the channels include a three-band signal EQ. These controls are used
to increase or decrease the LOW's, MID's, and HI's of the output signal.
Treble Control – This knob is used to adjust the treble levels of a channel allowing for a
maximum treble gain of +12dB or maximum decrease of -30dB. Turning the knob in a
counter-clockwise direction will decrease the amount of treble applied to a channel
signal, turning the knob in a clockwise direction will increase the amount of treble
applied to a channel signal.
Midrange Control – This knob is used to adjust the midrange levels of a channel
allowing for a maximum midrange gain of +12dB or maximum decrease of -30dB.
Turning the knob in a counter-clockwise direction will decrease the amount of
midrange applied to a channel signal, turning the knob in a clockwise direction will
increase the amount of midrange applied to a channel signal.
Bass Control – This knob is used to adjust the low frequency levels of a channel
allowing for a maximum bass gain of +12dB or maximum signal decrease of -30dB.
Turning the knob in a counter-clockwise direction will decrease the amount of bass
applied to a channel signal, turning the knob in a clockwise direction will increase the
amount of bass applied to a channel signal.
(25) Master Volume Level Indicators – The dual Master Level LED indicators are used to
detail the master output level. The meters will detail the output level of both the left and
right channels.
(26) Channel Fader – These faders are used to control the output signal of any source
assigned to its particular channel.
(27) Relay Button – This button activates the Relay function.
(28) Q-Start On/Off Switch – With this function you can use the crossfader to start and stop
the CD play. The On/Off Q-Start Switch activates the Fader "Q" Start feature. When the
Fader "Q" Start feature is activated, sliding the Crossfader (29) from left to right will play or
cue the CD player connected.
Example: Be sure the Fader "Q" Start feature is activated on both channels. Slide the
crossfader to the Channel 1 position (full left) and begin playback on CD drive 1. Slide the
crossfader to the Channel 2 position (far right). This will immediately trigger the play function
©American Audio® - www.americanaudio.eu Encore2000™ User Manual Page 26