Table of Contents
Advertisement
5 5
Appliance Preparation
A. Removing Non-combustible Facing
Material Assembly
The non-combustible assembly is located on right-hand
side of appliance (when looking from outdoor side of
appliance).
CAUTION
Handle with care.
• Non-combustible material may be damaged if dropped.
• Hold non-combustible pieces in place.
• Remove and save two screws from upper bracket.
• Remove non-combustible pieces.
• Remove and save three screws from lower bracket.
• Discard brackets.
• Replace screws in holes where brackets were attached
to appliance.
CAUTION
Handle with care.
• Avoid damaging protruding edges on outdoor side of
appliance.
B. Securing and Leveling the Appliance
WARNING
Fire Risk.
• Prevent contact with sagging, loose
insulation.
• Do NOT install against vapor barriers or
exposed insulation.
Placing Metal Hearth Strip
The metal hearth strip (approx. 46 inches x 4 inches) is
used to provide added protection where appliance and
outer structure meet.
• Place a generous bead of silicone caulk into the corner
of the protective hearth strip.
• Place the metal strip onto the structure where the outer
edge of the appliance will sit (see Figure 5.1). It should
overlap building paper to prevent water infi ltration.
Heat & Glo LifeStyle Collection • Twilight-II-B • 2108-900 Rev. E • 11/06
METAL HEARTH STRIP
UNDER EDGE OF
APPLIANCE
Figure 5.1 Positioning the Metal Hearth Strip
Removing and Replacing TL-Trim Kit Shroud for Color
Change (Optional)
If not changing color, skip to Step 15.
NOTE: The appliance ships with a black shroud or trim
attached. Alternate colors are available and must be attached
BEFORE the unit is installed.
Figure 5.2
Step 1. Remove black exterior cover plate from between
the left and right shroud sides by unhooking each side
from the shoulder bolts.
New Trim Kit includes:
• Surround
• Hood
• Wind Diffuser Assembly
• Cover Panel
APPLIANCE
EXTERIOR
11
Advertisement
Table of Contents
