Power Cord Set Requirements; Japanese Power Cord Requirements - HP W1972al User Manual

Power Cord Set Requirements

The monitor power supply is provided with Automatic Line Switching (ALS). This
feature allows the monitor to operate on input voltages between 100  120V~ or 200 
240V.
The power cord set (flexible cord or wall plug) received with the monitor meets the
requirements for use in the country where you purchased the equipment.
If you need to obtain a power cord for a different country, you should purchase a
power cord that is approved for use in that country.
The power cord must be rated for the product and for the voltage and current marked
on the product's electrical ratings label. The voltage and current rating of the cord
should be greater than the voltage and current rating marked on the product. In
addition, the cross-sectional area of the wire must be a minimum of 0.75 mm2 or 18
AWG, and the length of the cord must be between 6 feet (1.8 m) and 12 feet (3.6 m).
If you have questions about the type of power cord to use, contact an authorized HP
service provider. A power cord should be routed so that it is not likely to be walked on
or pinched by items placed upon it or against it. Particular attention should be paid to
the plug, electrical outlet, and the point where the cord exits from the product.

Japanese Power Cord Requirements

For use in Japan, use only the power cord received with this product.
CAUTION: Do not use the power cord received with this product on any other
products.
28
ENWW
Appendix C. Agency Regulatory Notices