Table of Contents
Advertisement
Configuration
Set the product in DMX mode to control with a DMX controller.
(DMX)
1.
2.
3.
Starting Address
When selecting a starting DMX address, always consider the number of DMX channels
the selected DMX mode uses. If you choose a starting address that is too high, you could
restrict the access to some of the product's channels.
The Freedom™ series uses up to four (4) DMX channels in 4-channel DMX mode, which
defines the highest configurable address to 509.
If you are not familiar with the DMX protocol, you may refer to the DMX Primer section in
the Technical Information chapter.
To select the starting address, do the following:
1.
2.
3.
4.
5.
6.
7.
DMX
The Freedom™ series has two DMX personalities. One is a basic 3-channel personality,
and the other is a more advanced 4-channel personality.
Personalities
To select either the Freedom™ series' 3- or 4-channel personalities, use the following
steps:
1.
2.
3.
4.
5.
6.
7.
Page 14 of 28
Connect the product to a suitable power outlet.
Turn the product on.
Connect a DMX cable from the DMX output of the DMX controller to the DMX input
socket on the product.
Press <MODE> repeatedly until SYS, ACt, SLAv, or S-1r shows on the display.
Use <UP> or <DOWN> to select SYS.
Press <ENTER>.
Use <UP> or <DOWN> to select SdAd from the menu.
Press <ENTER>.
Use <UP> or <DOWN> to select the starting address.
Press <ENTER>.
Press <MODE> repeatedly until SYS, ACt, SLAv, or S-1r shows on the display.
Use <UP> or <DOWN> to select SYS.
Press <ENTER>.
Use <UP> or <DOWN> to select d-CH from the menu.
Press <ENTER>.
Use <UP> or <DOWN> to select either the basic 3-channel mode (3CH) or the
advanced 4-channel mode (4CH).
Press <ENTER>.
Freedom™ series User Manual (Rev. 06)
Advertisement
Table of Contents
