Receiver Rear Panel - Extron electronics 60-871-12 User Manual

Receiver Rear Panel

The Rx (receiver) rear panel (see figure 4) has a DC power input, twisted pair link connection
and also has four female USB Type A hub connectors. AAP and Decora receivers have the
hub connectors on the front panel.
POWER
12V
1.0A MAX.
Rack Mount
d
AAP
Figure 4.
d
Power input connector — The receiver requires an external supply. Plug the included
12 VDC power supply into this 2-pole, 3.5 mm captive screw connector.
e
Link (twisted pair) connector — Connect the TP cable from the transmitter Link
connector (figure 3, item
CAUTION: Do not connect this port to a computer data or telecommunications
NOTE:
f
USB hub connectors (USB Extender Rx only) — The built-in four port hub uses four
female USB Type A connectors. The connections are USB 2.0 compatible, providing
+5 VDC at up to 500 mA to connected USB peripherals requiring power.
TP Cable Termination on page
See
HUB
1 3
DO NOT
2 4
CONNECT
TO LAN
LINK
e f
DO NOT
CONNECT
TO LAN
Receiver (Rx) Rear Panel Connectors
) to this RJ-45 female connector.
c
network.
In order for the AAPs to fit in a junction box, the TP cables and RJ-45
connectors should not have a boot installed.
e
POWER
12V
d
-.-A MAX
Decora
7, to properly wire the RJ-45 connectors.
USB Extenders • Installation and Operation
DO NOT
CONNECT
TO LAN
LINK
7