American Audio DCD-PRO310 MKII User Manual page 18

P U (R
LAYER NIT EAR
(26) DRIVE 1 AUDIO OUT R & L - These jacks send a left and right analog mono output signal.
Use these jacks to send standard audio to a mixer or receiver. The red colored jack
represents the right channel output and the white jack represents the left channel's output.
(27) REMOTE JACK - Connect the supplied 8 pin cable from this jack to the remote control's
connector. This will allow you to control the player functions with the remote unit.
(28) POWER CONNECTOR - This is the main power connection. Only use the supplied
polarized power cord. Use of any other power may result in severe damage to the unit. Be
sure the local power matches the unit's required power.
(29) Voltage Selector – Because power supplies vary from location to location a voltage
selector switch has been incorporated in the unit's design. This switch can select a voltage
input of 115V or 230V to accommodate the two major power sources. Always be sure to
disconnect the power plug before changing the voltage. Only dual voltage units have this
switch.
(30) DRIVE 2 AUDIO OUT R & L - These jacks send a left and right analog mono output signal.
Use these jacks to send standard audio to a mixer or receiver. The red colored jack
represents the right channel output and the white jack represents the left channels output.
L C D
IQUID RYSTAL
©American Audio®
)
(LCD)
ISPLAY
www.americanaudio.us DCD-PRO310 MKII™
Figure 6
Figure 7
User Manual Page 18