Table of Contents
Advertisement
MAIN SOURCE
Used to select which of the four video input channels or background is sent
to the Main video output. For more information, see Video
SUB SOURCE
Used to select which of the four video input channels or background will be
transitioned to or used as a sub source in an effect.
BG
Background Colour sets the background colour for use on the Main and Sub
Source Rails.
PIP
Picture In Picture can be set up in one of four preset positions, or manually
moved to any position on the screen.
FZ
Freezes the current PST or PGM image until toggled off.
FTB
FTB - Stands for Fade To Black. This is on the Main Source Rail only.
Pressing FTB will fade the PGM output to black. To fade back up to video
you need to press the key again.
PVW
Stands for Preview. This is on the Sub Source Rail only. When you press the
PVW Key you will see the active transition or effect previewed in the PST
window.
AUX SOURCE
Step.1
- Select AUX1 SEL or AUX2 SEL key.
Step.2 - Select SUB or MAIN key on the right side.
Step.3 - Select Channel 1~8 (If step.2 select MAIN, place select Channel
1~8 or BG on MAIN SOURCE).
Step.4 - Select AUX1 SEL or AUX2 SEL key to finish Aux Source setting.
HEADPHONE VOLUME CONTROL
Controls Headphone level and signal(s) present at the Headphone jack
Level is controlled by the rotary knob.
AUDIO MIXER
These CH1, CH2, AUX Audio Level are control CH1, CH2, AUX audio output
mix.
MASTER
Sliders to control audio levels for the Main audio output mix.
These faders correspond to the selector buttons above and control the
relative volume of each input in the master output as well as the master
output level. They are called faders because they are used to decrease
(rather than increase) the signal levels to make a balanced and pleasing mix.
When they are set at Unity, they pass the audio signal through at the same
level it was at when it entered this bus. This is why level setting at the Input
Bus is so important.
6
Source(Page 10).
Advertisement
Table of Contents
