Vertex Standard VX-4500 Operating Manual page 22

C
ALL
When using the DTMF Paging System
This feature, if enabled, allows the user to change the 3-digit Page Call code, used to
call other similarly-equipped stations. Press (or press and hold) the assigned pro-
grammable key, followed by the three digits representing the Page Call code of the
station you wish to call. Three tones will be heard after the last key is pressed (the
new code will now be transmitted).
The receiver squelch of the other station will be opened, and you can begin commu-
nication.
When using the 2-tone/5-tone Signaling System
This feature, if enabled, press (or press and hold) the assigned programmable key to
send a 2-tone/5-tone sequential tone.
When using the MDC1200 System
This feature, if enabled, press (or press and hold) the assigned programmable key to
send an MDC1200 code.
Press (or press and hold) the assigned programmable key to enter the "Call
Menu" mode.
Press the [ ] / [ ] keys (or [ P1 ] / [ P2 ] keys) to select the desired Call mode,
then press the [ P4 ] key to accept the selection. (You may cancel the selection by
pressing the [ P3 ] key).
Press the [ ] / [ ] (or [ P1 ] / [ P2 ] keys) to select the station to be called.
You may enter the station's ID number (four digits) directly from the microphone's
key ( [ 0 ] - [ 9 ] , [ A ] - [ D ] , [ # ] : substitute for "E", and [ ] : wild card), if the
optional MH-75
Press the PTT switch to send an MDC1200 call.
S S
ET ( This function is only available in the VX-4600 )
TATUS
Press (or press and hold) the assigned programmable key to change the 5-tone status
code. To change the status code, select the desired digit by pressing the [ P1 ] key,
then change the number by pressing the [ P2 ] / [ P3 ] key, and store the number by
pressing the [ P4 ] key.
You may enter the 5-tone status code directory from the microphone's numeric key
( [ 0 ] - [ 9 ] ), if the optional MH-75
20
A
DVANCED
microphone is used.
A8J
microphone is used.
A8J
VX-4500/-4600 S
O
PERATION
O M