Setting The Com Port Baud Rate - Lucent Technologies DEFINITY User Manual

Programming
In this situation, the Remote Module tries to reconnect with the
Switch Module a maximum of six times. If the connection with
the Switch Module is not re-established after the sixth try, the
modem disconnects and you must log in again.
4. To view the next Connect Rate, press
Connect Rate, press
displayed.

Setting the COM Port Baud Rate

You must set the baud rate for the COM 1 port on the Remote
Module. This is the rate at which data will be transmitted to and
from your remote terminal device, usually a computer. Two rates
are available: 19.2 kbps and 9.6 kbps. Follow these steps to set the
rate for the COM 1 port:
1. At the "Go Online?" screen, press
appears:
2
2. Press
following screen appears:
2
3. Press
3-8
Issue 2 July 1997
1
. Press
to get the Comm Port rate. If 9600 kbps is in effect, the
to change the setting or
3
; to view the previous
2
to accept the Connect Rate
3
until the following screen
1
to retain the existing setting.