Setting The Connect Rate - Lucent Technologies DEFINITY User Manual

Programming

Setting the Connect Rate

Setting the Connect Rate establishes the baud rate in kilobits per
second (kbps) for the communications between the Switch and
Remote Modules. Follow the steps and screens below to set the
Connect Rate.
1. At the "Go Online?" screen, press
appears:
2
Press
appears:
3
3. Press
six choices:
Auto—(Factory default). When the auto setting is selected,
the module tries to connect at the speed that will provide
the best performance with the fewest errors. The speed will
vary depending on line performance. If the module is
unable to connect at any of the available speeds, an error
message appears.
F-- —The Remote Module will connect at 19.2 kbps only,
the fastest rate.
3-6
Issue 2 July 1997
to change the connect rate. The following screen
until the Connect Rate you want appears. There are
3
until the following screen