Ford F-150 Owner's Manual page 294

E166716
2. Fully insert the jack handle through the
bumper hole and into the guide tube
through the access hole in the rear
bumper.
3. Turn the handle counterclockwise until
the tire is lowered to the ground, the
tire can be slid rearward and the cable
is slightly slack.
4. Slide the retainer through the center of
the wheel.
Jacking the vehicle
Front
E166717
Note: Use the frame rail as the jacking
location point, not the control arm.
F150 (TF6) , enUSA
Wheels and Tires
E142551
5. Block the diagonally opposite wheel.
6. Loosen each wheel lug nut one-half
Note: For the F-150 SVT Raptor, install the
saddle extension on the jack as shown in
the jack usage and storage instructions.
Note: For the F-150 SVT Raptor, you must
always use the jack saddle extension.
291
Obtain the spare tire and jack from
their storage locations. Note: The
F-150 SVT Raptor also includes a
chock, saddle extension and wing
bolt.Use the tip of the lug wrench to
remove any wheel trim that is blocking
the lug nuts.
turn counterclockwise, but do not
remove them until the wheel is raised
off the ground.