Table 12: Device Configuration - Settings/Advanced Settings - Grandstream Networks GXP1100/1105 User Manual

802.1x Mode
Multi Purpose Key X
Time Zone
Self-Defined Time
Zone
Table 12: Device Configuration – Settings /Advanced Settings
Admin
Password
Layer 3 QoS
Layer 2 QoS
Local RTP port
Use Random Port
Grandstream Networks, Inc.
This option allows the user to enable/disable 802.1x mode on the phone. The default
value is disabled. To enable 802.1x mode, this field should be set to EAP-MD5.
Once enabled, the user would be required to enter the following information below to
be authenticated on the network:
•
Identity
•
MD5 Password
These options are used to assign a function to the corresponding multiple purpose
key. Options available are:
1. Speed Dial
2. Dial DTMF
3. Call Return – Call the last answered number
This parameter controls the date/time display according to the specified time zone.
If "Allow DHCP Option 2 to override Time Zone setting" is checked, the time zone will
be overridden by the DHCP server.
This parameter allows the users to define their own time zone.
The syntax is: std offset dst [offset], start [/time], end [/time]
Default is set to: MTZ+6MDT+5,M3.2.0,M11.1.0
MTZ+6MDT+5,
This indicates a time zone with 6 hours offset with 1 hour ahead which is U.S central
time. If it is positive (+) if the local time zone is west of the Prime Meridian (A.K.A:
International or Greenwich Meridian) and negative (-) if it is east.
M3.2.0,M11.1.0
The 1st number indicates Month: 1,2,3.., 12 (for Jan, Feb, .., Dec)
The 2nd number indicates the nth iteration of the weekday: (1st Sunday, 3
Tuesday...)
The 3rd number indicates weekday: 0,1,2,..,6( for Sun, Mon, Tues,..,Sat)
Therefore, this example is the DST which starts from the second Sunday of March to
the 1st Sunday of November.
Administrator password. Only the administrator can access the "Advanced Settings"
and "Account Settings" page. Password field is purposely blank for security reasons
after clicking update and saved. The maximum password length is 25 characters.
This field defines the layer 3 QoS parameter. It is the value used for IP Precedence
or Diff-Serv or MPLS. Default value is 12.
This contains the value used for layer 2 802.1Q/VLAN tag and 802.1p priority value.
Default setting is 0.
This parameter defines the local RTP port pair used to listen and transmit. It is the
base RTP port for channel 0. When configured, channel 0 will use this port _value
for RTP; channel 1 will use port_value+2 for RTP. Local RTP port ranges from 1024
to 65400 and must be even. The default value is 5004.
This parameter, when set to "Yes", will force random generation of both the local
SIP and RTP ports. This is usually necessary when multiple GXPs are behind the
same NAT. Default is "No".
GXP1100/1105 User Manual
Firmware version: 1.0.1.80
rd
Page 15 of 29
Last Updated: 07/2011