Configuring Bluetooth Connection Settings - Clarion ClarionMIND NR1UB Owner's Manual

NOTE
• You can perform pairing while the unit is in
standby. In this case, tap the [Discovery
Mode] key on the Bluetooth Device screen,
and the cell phone will search for Bluetooth
devices. The PIN code and device name will
be displayed while the unit stands by, so
perform the certification and connection
process on the cell phone.
• When [DUN] key is ON, the dialup connection
will be established when the Bluetooth device
is connected. The initial default setting is
"OFF".
• To delete a paired Bluetooth device, tap the
[Delete] key and then select the device on the
list.
• You can have up to five Bluetooth devices
paired with the unit at one time. To create a
new pairing when there are already five
devices paired, you first need to delete one of
the currently paired devices.
• If you cancel an ongoing search, all the
Bluetooth devices found up to that point will
be listed on the display.
Chapter 3 Connecting to a Network
3-3
Configuring Bluetooth
Connection Settings
After pairing the unit with a Bluetooth-enabled
cell phone, use the procedure below to
configure setting for a dialup connection to a
network.
NOTE
Before configuring dialup connection settings
on the unit, you must first conclude a contract
with an Internet service provider and obtain an
account and password from the provider.
3-3-1
Configuring Connection Destination
Settings
1
On the Home screen, tap the [Control
Panel] key.
This displays the Control Panel screen.
2
Tap the [Dial-Up Network] key.
This displays the Dial-Up Network screen.
NR1UB/NR1UW/NR1UR
35