Setup; Introduction; Unpacking The Carton; Selecting A Location For Your System - Bose Wave Owner's Manual

Music system multi-cd changer
Hide thumbs Also See for Wave:
Table of Contents

Advertisement

S
ETUP

Introduction

Thank you for purchasing the Bose
system Multi-CD Changer accessory.
Adding the Multi-CD Changer to your Wave
system provides you with some valuable benefits:
®
• A four-disc Wave
music system – Allows you to
load and play up to four audio CDs. Provides hours
of uninterrupted CD music.
• Elegant integrated pedestal design – Using the
same footprint as the Wave
changer complements the elegance and simplicity
of the system.
• One integrated remote control – Provides the
simplicity of using the remote control that came with
®
your Wave
music system and one-touch selection of
all built-in sources.
• Multiple source switching – By adding two input
connections for external audio devices, you can enjoy
listening to one or two other audio sources in your
home through the Wave

Unpacking the carton

Carefully unpack your Wave
Changer and save all packing materials for possible
future use. The original packing materials provide the
safest way to transport your new Multi-CD Changer.
Make sure you received the parts shown in the following
diagram. If any part appears damaged, do not attempt
to use it. Notify Bose customer service immediately
(see phone numbers on the inside back cover).
®
Wave
music system Multi-CD Changer
6 – English
®
®
Wave
music
®
music
®
music system, the
®
music system.
®
music system Multi-CD
Selecting a location for
your system
Your Multi-CD Changer is designed to fit directly under
®
your Wave
music system. Before you connect the
Multi-CD Changer to the Wave
good location for the complete system using the follow-
ing guidelines.
• Place the system on a table or other flat surface.
• To enjoy maximum performance, place the system
across the room from where you will be listening.
• Place the system within two feet of a wall, and avoid
placing it directly in a corner.
CAUTION: DO NOT place your system on a heat-sensitive
surface. Like all electrical equipment, it generates some
heat.
CAUTION: DO NOT use your system in a damp location
or any other place where moisture can get inside.
Note: DO NOT place your system on a metal surface.
It could interfere with AM reception.
Seating your Wave
system on the Multi-CD
Changer
With the changer placed in your chosen location, care-
fully set your Wave
®
music system on top of the changer.
• Make sure the rear feet of the Wave
into the recesses on top of the changer.
®
• Make sure the Wave
side edges of both units are aligned.
®
music system, select a
®
music
®
music system fit
music system sits flat and the

Advertisement

Table of Contents
loading

Table of Contents