Precor C954i Owner's Manual page 13

C O M M E R C
Diagram 7 Attach the
display console
to the left upright
support.
Display console
Display cable
Screws (A) with
washers (B)
Left side upright
support
CAUTION: To avoid damage to the display cable, read the following steps
carefully. Damage to the cable due to improper assembly is not covered
by the Precor limited warranty.
6. Secure the display console to the left upright support. Diagram 7.
Remove any tape or wire ties that secure the display cable. Unwrap the cable
to remove kinks. Ask an assistant to hold the display console in place while
you attach it to the left upright support using two buttonhead screws (A) with
washer (B). Finger tighten.
Diagram 8 Remove right
side front panel
screws.
Right side
mounting bracket
Front panel
fasteners
7. Prepare to attach the right side upright. Diagram 8. Take the following steps:
a. Remove the shipping fasteners from the right front panel. Follow the same
process as in step 5a. With the supplied hex key and a -inch box end wrench,
loosen and remove the two bolts and nuts on the right side of the front panel.
I A L P R O D U C T S D I V I S I O N
page 13