Everything you need to boot
this motherboard is included in
this Easy Installation Guide.
For
more
information,
complete
Online User's Manual
can be found in the
Bonus
Pack
CD. Thanks for the help
of saving our earth.
Screw Pack for I/O Port
Easy Installation Guide x 1
MB Layout and jumper setting sticker label x1
COM2 Cable x 1
Ultra320 SCSI Cable x 1 (DXPS Plus only)
Bonus Pack CD x 1
Norton Anti-Virus CD x 1
I/O Port Bracket x 1
Floppy/IDE Cable Package
Plate plastic for retention module assembly x2
User Manual x1
PART NO: 90.51N30.002
DOC. NO: DXPSP-EG-E0209A
a
Plug in the CPU fan cable to the 3-pin CPU FAN connector and housing fan cable to the HFan
connectors.
1. Installing CPU
CPU Pin 1 and cut edge
CPU socket lever
2. Installing CPU & Housing Fan
SENSOR
+12V
GND
HFan 1
SENSOR
+12V
GND
HFan 3
SENSOR
+12V
GND
HFan 2
1.
Pull up the CPU socket lever and up to
90-degree angle.
2.
Locate Pin 1 in the socket and look for a
(golden) cut edge on the CPU upper interface.
Match Pin 1 and cut edge. Then insert the
CPU into the socket.
3.
Press down the CPU socket lever and finish
CPU installation.
Note: If you do not match the CPU
socket Pin 1 and CPU cut edge
well, it may damage the CPU.
CPU Fan 1
CPU Fan 2
Note: Some CPU fans do not have sensor pin, so that
cannot support fan monitoring.
GND
+12V
SENSOR
GND
+12V
SENSOR