Connecting Ide And Floppy Cables - AOpen DXPS Easy Installation Manual

3. Install DIMM Modules
This motherboard has four 184-pin DIMM sockets that allow you to install PC200/266
Registered memory up to 4.0GB.
4. Connecting ATX Power Connector
This motherboard comes with a 24-pin and 8-pin ATX power connector. Make sure you
plug in the right direction. We strongly recommend you to connect the 8-pin 12V ATX
connector before connecting the 24-pin ATX power connector
DIMM 1
DIMM 2
DIMM 3
DIMM 4
2 1
+12V
Ground
+12V
Ground
+12V Ground
+12V
Ground
2 1
+3.3V +3.3V
-12V
+3.3V
Ground
Ground
PS_ON +5V
Ground
Ground
Ground +5V
Ground Ground
NC
PWR_OK
+5V +5Vsb
+5V +12V
+5V
+12V
+3.3V
Ground
5. Connecting 68pin Ultra320 SCSI Cable (DXPS Plus/-U)
The DXPS Plus provides two 68-pin Ultra320 SCSI connectors for 16-bit or 16-bit differential SCSI
devices. The Adaptec AIC-7902W controller provides 320MB/sec maximum data throughput per
channel available.

6. Connecting IDE and Floppy Cables

Connect 34-pin floppy cable and 40-pin IDE cable to floppy connector FDC and IDE
connector. Pin1 of cable is normally marked with red color. Addition to normal connectors,
we provide you a slim type IDE2 connector and a slim type FDD connector. Please be
informed that DO NOT connect Secondary IDE Slim connector and Secondary IDE
Connector at the same time. As well as DO NOT connect FDD connector and slim FDD
connector at the same time.
Secondary IDE Slim
Connector
Secondary IDE Channel
Primary IDE Channel
Slim FDD
Connector
FDD
Connector