Advertisement
MULTI / MULTI XL
1 DIN type
1.5 DIN type
FI-504
FI-507
The FI-504 and FI-507 feature large digital displays with
easy-to-read characters presenting all of the information
available in the CAN bus network*. Alternating data display
mode switches the user-selected information in 3-second
intervals.
Data displayed
•Displays all information on the FI-50 series* •NAVIGATION
(Bearing/distance to WPT, XTE, WPT number/name, L/L, Satellites
tracked, Roll & Pitch) •ENVIRONMENT (Battery voltage, Time & Date)
•ENGINE (Trip fuel used, Fuel consumption, Engine RPM)
Except ROT. ROT can be displayed on FI-505.
Specifications of FI-50 series
Display:
Power supply:
Temperature:
Waterproofing:
Sensors and Accessories (Option)
Wind Transducer
FI-5001/FI-5001L
Power supply:
Transducer cable: 30/50 m
Depth/Speed/Temp Sensor
DST-800
Frequency: 235 kHz
Cable:
COURSE PILOT
RUDDER
FI-505
The FI-505 provides a digital compass
When connected to an autopilot,
readout with an analog "Off Course"
the analog FI-506 Rudder Angle
needle that greatly assists the
Display shows precise rudder
helmsman in maintaining a desired
angle information.
course. When connected to satellite
compass, smooth and precise ROT
Data displayed
(Rate Of Turn) of the boat is shown
•Rudder angle
with the analog needle. The needle
can also be used to verify autopilot
steering performance.
Data displayed
•Current heading •Locked heading
•Average heading •Course over ground
•ROT
Analog and digital LCD (FI-501, 502, 505)
Digital LCD (FI-503, 504, 507)
Analog (FI-506)
12 VDC, less than 0.1 A
–15°C to +55°C
IP56
FI-5001
FI-5001L
12 VDC, less than 40 mA
Junction Box
FI-5002
CAN bus backbone x 2 ports
6 m
CAN bus x 6 ports
Power supply: 12 VDC, less than 2 A
Easy to install
Surface Mount the displays with a hole saw and install 4 screws
under the front bezel. Installations are easy and clean with a finished
FI-506
appearance (1"(26mm)bulkhead protrusion)
Surface mount installation
The units are designed to match the
NavNet 3D series and other navigation
equipment. The "Plug and Play" system
utilizes CAN bus interface protocol, which
gives the system exceptional interface
ability.
Easy to Read with Silver Bright LCD Display
The FI-50 Series utilize high-contrast, backlit LCD displays for
superior viewing even in direct sunlight. Each unit features an
easy-to-read display and 4 simple programming buttons for
operation. The function for each key and combination are printed
directly on the front panel.
FI-503 DIGITAL
22 mm
22 mm
Operational guide description on the front panel
Optional "Low Profile" Flush Mounting front panels provide
a cosmetic match to NN3D Displays and a custom console
appearance (0.4"(10mm)bulkhead protrusion)
Flush mount installation
with optional front panel
Wind Transducer
FI-501
FI-503
Automatic Backlight Adjustment
The FI-50 series of instruments minimize power consumption
by turning off the backlight during the daytime. Sensors on
the front panel measure ambient lighting conditions and
adjust the on/off condition of the display backlighting
accordingly.
FI-504 MULTI
Daytime
41 mm
Automatic Detection
MULTI FUNCTION
DISPLAY
JUNCTION
BOX
Sunset or after
Back Light
Turns On
Back Light
Turns Off
Advertisement
