Specifications - Audio Technica AEW-R4100 Features & Specifications

front
ON
POWER
ALERT
OFF
UHF SYNTHESIZED DIVERSITY RECEIVER AEW-R4100
LEVEL
PHONES MIN– –MAX
IN
INSTRUMENT
0/-6/-12
ANT. B
ATTN (dB)
OUTPUT
(UNBAL.)
back
MODE/SET
RX NAME
BALANCED
IN
MIC OUTPUT
ANT. A
GROUND GROUND IN – LINK – OUT WARNING:
LIFT
THIS APPARATUS MUST BE EARTHED.

Specifications

UHF operating frequencies
Number of frequencies
Frequency stability
Operating temperature range
Frequency response
Receiving system
Signal-to-noise ratio
Total harmonic distortion
Intermediate frequency
Audio output (attn switch at "0")
Audio output attenuator (ATTN)
Output connectors
Headphone output
Accessories included
In the interest of standards development, A.T.U.S. offers full
details on its test methods to other industry
AC
˜
100V-240V
50/60Hz
Specifications are subject to change without notice.
Audio-Technica U.S., Inc., 1221 Commerce Drive, Stow, Ohio 44224
Audio-Technica Limited, Old Lane, Leeds LS11 8AG England
©2010 Audio-Technica U.S., Inc.
AEW-R4100
Overall system
Band C: 541.500–566.375 MHz;
Band D: 655.500–680.375 MHz
996 total per band (25 kHz increments)
±0.005%, Phase Lock Loop frequency control
Modulation mode
FM
Normal deviation ±5 kHz
Operating range 300' typical
5° C (41° F) to 45° C (113° F)
70 Hz to 15 kHz
AEW-R4100 receiver
Dual independent RF sections, automatic-
switching diversity
Image rejection 60 dB typical
115 dB at 40 kHz deviation (IEC-weighted),
75 kHz maximum modulation
≤1% (10 kHz deviation at 1 kHz)
Sensitivity 20 dBµV (S/N 70 dB at 5 kHz deviation,
IEC-weighted)
65.75 MHz, 10.7 MHz
Microphone: 25 mV (at 1 kHz, ±5 kHz devia-
tion, 10k ohm load),
Instrument: 50 mV (at 1 kHz, ±5 kHz devia-
tion, 10k ohm load)
Three-position switch: 0 / –6 / –12 dB
Microphone: XLRM-type, (balanced);
Instrument: 6.3 mm (
phone jack
Connector: 6.3 mm (
phone jack; Power output: 10 mW + 10 mW
at 1 kHz, ±5 kHz deviation into 32 ohms;
maximum output, 220 mW + 220 mW into
32 ohms
Antenna power DC 10V-12V, 20 mA (BNC-type jack)
Power supply
100-240V AC 50/60 Hz, 8W
Dimensions
211.0 mm (8.31") W x 44.0 mm (1.74") H x
235.0 mm (9.26") D
Net weight 1.7 kg (3.8 lbs) (without accessories)
Detachable IEC-type AC power cable; two
flexible UHF half-wave antennas; link cable;
rack-mount adapters
professionals on request.
audio-technica.com
47
/ ") TS unbalanced
1
4
/ ") TRS ("stereo")
1
4
0001-0017-01