Table of Contents
Advertisement
Specifications
OVERALL SYSTEM
Operating Frequency
Number of Channels
Frequency Stability
Modulation Mode
Normal Deviation
Tone Squelch Frequency
Operating Range
Operating Temperature Range
Frequency Response
ATW-R92 RECEIVER
Receiving System
Image Rejection
Signal-to-noise Ratio
Total Harmonic Distortion
Sensitivity
Intermediate Frequencies
Audio Output
Unbalanced:
Balanced:
Output Connectors
Unbalanced:
Balanced:
Headphone Output
Antenna Inputs
Antenna Outputs
Antenna Power
Power Supply
Dimensions
Weight
Accessories Included
In the interest of standards development, A. T .U.S. offers full details on its test methods
to other industry professionals on request.
For future reference, please record your system information here (the serial number appears on the bottom of the
receiver):
Receiver
ATW-R92
6
UHF band, 800.550 to 819.700 MHz
100 total
±0.005%, Phase Lock Loop
frequency control
FM
±5 kHz
32.768 kHz
90m typical
5 C degree to 45 C degree
100 Hz to 15 kHz
Dual independent tuners, automatic
switching diversity
>100 dB
>107 dB (IEC-weighted at ±40 kHz
deviation)
<1 % (±5 kHz deviation at 1 kHz)
18 dBµV (S/N 60 dB at ±5 kHz
deviation, IEC-weighted)
54.25 MHz, 10.7 MHz
40 mV (at 1 kHz, ±5 kHz deviation,
1M ohm load)
4 mV (at 1 kHz, ±5 kHz deviation,
600 ohm load)
6.3mm phone jack
XLRM-type
20 mW max. into 16 ohms
(at 1 kHz, ±5 kHz deviation)
BNC-type, 50 ohms, two "A" and
two "B"
BNC-type, 50 ohms, two "A" and
two "B"
+12V DC on input jacks, 20 mA max.
from "A" jacks, 20 mA max. from
"B" jacks
120-240V AC, 50/60 Hz, autoadjusting
430.0 mm W x 44.0 mm H x 175.0 mm D
without antennas, rack-mount adapters
2.9 kg
Two flexible UHF antennas,
rack-mount adapters, power cable and
power cable clamp
Serial Number
Receiver Accessories
ATW-A20
Pair of UHF ground-plane antennas with
for mounting to microphone stands, etc. T akes RF
cables with BNC connectors, not included.
ATW-D80
UHF (800 MHz) active unity-gain antenna distribution
system provides two "1-in, 4-out" RF channels; connects
a pair of antennas to as many as four diversity receivers.
Includes four DC interconnect cables to power up to
four receivers, eight RF output cables and two rack-mount
adapters. Mounts in a single (1U) 19" rack space.
/
"-27 thread
5
8
Advertisement
Table of Contents
