Pan/Bal Control; Peak Led; Level Control; Main Mix Level Dial - Alto AMX-140FX USB User Manual

In the AMX-140FX USB model, excluding sending out directly to the external effect or processor equipment, the AUX SEND2
will also be sent to the internal onboard effect module.

4.8 PAN/BAL Control

Abbreviation of PANORAMA control for mono channels, for the stereo channels, always says, BALANCE control.
You can adjust the stereo image of the signal via this control. Keep this control in center position and your signal
will be positioned in the middle of stage. Turn this control fully counterclockwise and the signal will be present only
on the left speaker and vice-versa.

4.9 PEAK LED

Inside your AMX-140FX USB the audio signal is monitored in several different stages and then sent to the PEAK LED.
When this LED blinks, it warns you that you are reaching signal saturation and possible distortion. The PEAK LED will
blink with a level that is 6dB before actual clipping.

4.10 LEVEL Control

This control will adjust the overall level of this channel and set the amount of signal sent to the main output.

4.11 MAIN MIX LEVEL Dial

This control sets the amount of signal sent either
to the main out socket or to the tape output.

4.12 OUTPUT LEVEL LED Display

This stereo 12 segments LED meter will indicate
the level of the overall output signal.

4.13 POWER LED

This LED indicates when the power is on in your
AMX-140FX USB.

4.14 PHANTOM LED

This LED indicates when the phantom power is
switched on.

4.15 TAPE Switches

- 2TK TO CTRL ROOM
Engaging this button to route the 2 TRACK IN signal
into the control room output.
- 2TK TO MIX
Engaging this button to route the 2 TRACK IN signal
into the main output.
11
12
13
14
15
16
17
18
19
21
- MAX
/
PHONES
CTRL ROOM
-7
-10
-20
-30
16
-
MAIN MIX LEVEL
10
20
2TK TO 2TK TO
CTRL ROOM CTRL ROOM
- MAX
2TK IN
2TK TO MIX
TAPE
OUTPUT LEVEL
-2 0
-4 2
4 L
7
10
CLIP
R
PWR PH
+15
14
18
19
15
17