Pioneer RCS-656HX Operating Instructions Manual page 90

Playback
08
Playing CDs and WMA/MP3 discs
The table below shows the basic playback controls for
1
audio CDs , and WMA/MP3 files.
Press to start playback.
PLAY
Press to stop playback.
STOP
Pauses playback, or restarts playback when
PAUSE
paused.
Except WMA: Press to start scanning. Press
again to increase the scanning speed.
(There are two scan speeds; the current
scan speed is shown on-screen.)
Press to skip to previous/next track (or folder
for WMA/MP3 disc). (During playback you
PREV NEXT
can also use the front panel CH +/– buttons.)
During playback, enter a track number then
SET UP /TUNE+ SR+
1 2 3
press ENTER to skip directly to that track.
/ST– ENTER /ST+
4 5 6
Press CLEAR to clear a number entry and
MCACC /TUNE– TEST TONE
start again.
7 8 9
ADVANCED SOUND
0
CLEAR
ENTER
Note
1 If you want to play a DTS audio CD, make sure the recorder is connected to a DTS-compatible amp/receiver with a digital connection. Noise
will be output through the analog outputs. Also make sure that STEREO is selected using the AUDIO button (see Switching audio channels
on page 96).
2 When playing in PBC mode, some playback features, such as search, repeat and program play are not available. You can play a PBC Video
CD/Super VCD in non-PBC mode by starting playback using the Disc Navigator (see Using the Disc Navigator with playback-only discs on
page 92).
90
En
Playing Video CD/Super VCDs
The table below shows the basic playback controls for
Video CD/Super VCDs.
Some discs feature Playback Control (PBC for short)
menus. These discs show PBC in the display when you
load them and display a menu on-screen from where you
2
can select what to watch.
Press to start playback.
PLAY
Video CD only: If RESUME is displayed on-
screen, playback starts from the place last
stopped.
Press to stop playback.
STOP
Video CD only: You can resume playback
from the same point by pressing
(Press STOP again to cancel the resume
function.)
Pauses playback, or restarts playback when
PAUSE
paused.
Press to start scanning. Press repeatedly to
increase the scanning speed.
Press to skip to previous/next track.
When a PBC menu is displayed, press to
PREV NEXT
display the previous/next page. (During
playback you can also use the front panel CH
+/– buttons.)
During playback, enter a track number then
SET UP /TUNE+ SR+
1 2 3
press ENTER to skip directly to that track.
/ST– ENTER /ST+
4 5 6
Press CLEAR to clear a number entry and
MCACC /TUNE– TEST TONE
7 8 9
start again.
ADVANCED SOUND
0
While a PBC menu screen is displayed, use
CLEAR
to select numbered menu items.
ENTER
Video CD in non-PBC mode only:
Press to skip backward/forward progressively
CM CM
BACK SKIP
ENTER
up to a maximum of ten minutes forward or
three minutes back.
While paused, press and hold to start slow-
/
motion playback. Press repeatedly to
change the playback speed (forward only).
While paused, press to advance a single
frame (forward only).
Press to display the disc menu of a Video
RETURN
CD/Super VCD playing in PBC mode.
PLAY.