Pioneer RCS-656HX Operating Instructions Manual page 138

The Initial Setup menu
16
Setting
Remote Control
Mode
AV. Link
When set to Pass Through, make sure to set Power Save (page 129) to Off.
DivX VOD
Set Preview
(HDD only)
CI Information
Software Update
Additional information about the TV system
settings
About the input line system
This recorder is compatible with PAL, SECAM, 3.58 NTSC
and PAL-60 TV systems. The Input Line System and Input
Colour System settings determine how the recorder
treats incoming video signals from an external input.
Please note the following points when changing the
input line system:
• When the current input is a built-in tuner channel
preset, changing the input line system will usually
also affect the input line system of the AV2(INPUT 1/
DECODER) input. However if the AV2/L1 In setting is
set to Decoder, then the L2 input is affected instead.
• If, when the Input Line System setting is changed, the
screen goes blank (due to incompatibility with your
TV), you can switch back by pressing and holding the
front panel
(also front panel) while the recorder is stopped.
• When you switch the Input Line System setting the
Copy List is erased. If you switch the setting using the
STOP button and VIDEO IN buttons as described
above, there is no confirmation, so please use with
care.
138
En
Options
Recorder 1–3
(default: Recorder 1)
This Recorder Only
•
Pass Through
Registration Code
Quick Preview •
Normal
Next Screen
Next Screen
STOP button then pressing VIDEO IN
Explanation
If you are using more than one recorder in the same room, set them to
different IDs. This setting sets the recorder ID; to change the remote
controller ID, press and hold RETURN/EXIT then press 1, 2 or 3 to set. The
remote will only control a recorder with the same ID.
Signals received through the AV input when the recorder is in standby are
not passed through to the AV output.
Signals received when in standby are passed though to the output for
connected devices. (Note that during EPG data download, the EPG data is
not passed through.)
Use to display the recorder's DivX registration code. See DivX video com-
patibility on page 43 and DivX® VOD content on page 43.
When in the Disc Navigator, the thumbnail video plays short excerpts from
throughout the selected title. (Note that edited titles that will play normally
from the beginning.)
The thumbnail video plays from the beginning of the title.
This option displays a menu of CI card functions. Consult your service
provider for more information on the functions available.
The Software Update function can check for and download updated system
software for the digital tuner. See Using Software Update (Digital tuner) on
page 139.
• You can't mix recordings of different TV line systems
on the same disc.
• When you change this setting, the Input Colour
System setting also changes (see below).
About NTSC on PAL TV
Depending on the Input Line System setting and the
NTSC on PAL TV setting, the signal format output when
the recorder is stopped varies as shown in the table
below.
Input Line System
625 System
525 System
NTSC on PAL Output when
TV stopped
Off PAL
On PAL
Off NTSC
On PAL–60