Connecting An Audio System With Analogue Two-Channel Stereo Sound; Connecting The Power Cord; Inserting Batteries In The Remote Control - Grundig CINIO GDP 5240 User Manual

CONNECTION AND PREPARATION
Connecting an audio system with analogue
two-channel stereo sound
As an alternative to using the television's speakers, the sound can also be played
back through an audio system. This can improve audio playback.
R L
AUDIO
INPUT
1 Plug a standard cinch cable into the
player and into the corresponding socket on the audio system.
VIDEO OUT
S VIDEO OUT
Caution:
Do not connect the
the PHONO (record player) input socket on the audio system. Please observe
the information on downmix on page 53, "Selecting sound mode type"
section.

Connecting the power cord

1
Plug the mains cable supplied into the
of the DVD player.
2
Plug the mains cable into the wall socket.

Inserting batteries in the remote control

1
Open the battery compartment by pressing the snap-catch, and remove the
lid.
2
When inserting the batteries (e.g. R06 or AA, 2 x 1.5 V), observe the
polarity marked on the battery compartment.
3 Close the battery compartment.
Note:
If the DVD player no longer reacts properly to remote control commands, the
batteries may be flat. Be sure to remove used batteries. The manufacturer
accepts no liability for damage resulting from used batteries.
If the message »Batt. low« is displayed on the television screen when the
remote control is operated, you should replace the batteries.
Environmental note:
Batteries, including those which contain no heavy metal, may not be
disposed of with household waste. Please dispose of used batteries in an
environmentally sound manner. Find out about the legal regulations which
apply in your area.
_______________________________________
VIDEO OUT
2
S VIDEO OUT
MADE IN PRC
»AUDIO OUT L
»AUDIO OUT L R« socket on the DVD player to
»110-240V
R« socket of the DVD
~
« socket on the back
15