American DJ Accu Spot 250 II User Instructions page 9

Accu Spot 250 II™
DLOF (Lamp Adjustment) - With this function you can adjust the
lamp via the control board. In this mode, the device will not
react to any control signal.
DLAY - With this function you can put the lamp on a delay time.
SPOT - This provides a spot beam for better lamp optimization.
DFSE - This will reset the unit to the default settings.
FEED - With this function you can activate or deactivate the
pan/tilt error correction. So if you units head gets knocked out
of place the unit will automatically go back to the last setting.
VER - This will display the software version
ADJU - Fixture code is "C050".
CH01~CH30 for motor calibration.
EDIT MENU -
STEP (Step) - Steps to be used in Edit Programming. See ediit
program. See page 31.
SCXX (SC01 - SC30) - These are the scenes that are stored in
your program. There are a total of 30 scenes.
Submenus:
C-01~C-30 - Edit the channels of each scene.
TIME - Set the Time for each scene.
CEDT - Edit the program via external controller.
REC - This will auto save your custom program.
RUN - This will run your custom program.
American DJ - www.americandj.com - Accu Spot 250 II™ Instruction Manual Page 17
®
System Menu Accu Spot 250 II™
On-Board System Menu.
easy to navigate system menu. This next section will detail the func-
tions of each command in the system menu.
Enter Button -
on the front of the unit. Press this button to activate the system menu.
Tap the UP button (4) until you reach function you wish to change.
When you reach the function you wish to change tap the ENTER button.
When a function is selected the menu will begin to flash, use the UP
button to change the function. Once your changes are made tap the
ENTER button again to lock the change in the system, if the ENTER
button is not selected within eight seconds the system will automati-
cally return to menu section. To exit without making any changes tap
the MODE/ESC button (3).
ADDR MENU -
ADDR
1. Access the main menu.
2. Tap the UP button until "ADDR" is displayed, press ENTER.
3. "A001" will now be displayed. Press the UP or DOWN buttons
to find your desired address. Press ENTER to confirm.
4. The display will show "PASS", and then display, your selected
address again.
5. Press the MODE/ESC button to return to the main menu.
When the display is on "A001", you can directly press the UP
or DN buttons to change the DMX start address.
TEST MENU -
TEST
1. Access the main menu.
2. Tap the UP button until "TEST" is displayed, press ENTER.
American DJ
The Accu Spot 250 II™ comes with an
To access the main menu locate the ENTER button (6)
DMX Address Setting via control board -
- This will test the functions of each channel.
- www.americandj.com - Accu Spot 250 II™ Instruction Manual Page 18
®
System Menu