American DJ Accu Spot 250 II User Instructions page 14

Accu Spot 250 II™
Channel 3s' value to "57".
2ND EXAMPLE: If you want the address to be 420, you must
first set the address that is currently assingned to the unit.If you
want the set the address to 420, set Channel 1s' value to "7",
Channel 2s' value to "8", and Channel 3s to "164". (256 + 164 =
420)
MODE
- Choose between eight channels or nine channels.
Ninth channel is dimming.
1. Access the main menu.
2. Tap the UP button until "SPEC" is displayed, press ENTER.
3. Tap the UP button until "MODE" is displayed, press ENTER.
4. By pressing the UP button or Down button chose "8CH" or
"9CH". When the unit is switched to nine channels the unit will
reset.
5. Press ENTER to confirm your selection.
6. Press MODE/ESC to return to the main menu.
DLOF
- With this function you can adjust the lamp via
the control board. The shutter opens and the lamp can be
adjusted. In this mode, the device will not react to any con-
trol signal.
1. Access the main menu.
2. Tap the UP button until "SPEC" is displayed, press ENTER.
3. Tap the UP button until "SPOT" is displayed, press ENTER.
4. The display will show "ON/OFF".
5. Press the UP button to select "ON" to activate this function,
or "OFF" to deactivate this function.
6. Press ENTER to confirm.
American DJ - www.americandj.com - Accu Spot 250 II™ Instruction Manual Page 27
®
System Menu Accu Spot 250 II™
7. Press MODE/ESC to return to the main menu.
DLAY
1. Access the main menu.
2. Tap the UP button until "SPEC" is displayed, press ENTER.
3. Tap the UP button until "DLAY" is displayed, press ENTER.
4. The display shows "D-00". Press the UP button to select the
desired delay between "00" and "59" minutes. For example, if
you select "D-03" the lamp will ignite after 3 minutes.
5. Press ENTER to confirm.
6. Press MODE/ESC to return to the main menu.
SPOT
the control board. The shutter opens and the lamp can be
adjusted. In this mode, the device will not react to any con-
trol signal.
1. Access the main menu.
2. Tap the UP button until "SPEC" is displayed, press ENTER.
3. Tap the UP button until "SPOT" is displayed, press ENTER.
4. The display will show "ON/OFF".
5. Press the UP button to select "ON" to activate this function,
or "OFF" to deactivate this function.
6. Press ENTER to confirm.
7. Press MODE/ESC to return to the main menu.
DFSE
settings of the device. All settings will be set back to the
default values. Any edited scenes will be lost. When restor-
ing the factory settings the unit must be set to the address
that the unit was in when you started editing.
American DJ
- With this function you can delay the lamp ignition.
- With this function you can adjust the lamp via
- With this function you can restore the factory
- www.americandj.com - Accu Spot 250 II™ Instruction Manual Page 28
®
System Menu