American DJ Accu Spot 250 II User Instructions page 13

Accu Spot 250 II™
5. The display will show "ON/OFF". Press the UP button to
select "ON" to activate this function, or "OFF" to deactivate this
function.
6. Press ENTER to confirm.
7. Press MODE/ESC to return to the main menu.
FLIP -
This function will reverse the display 180º.
1. Access the main menu.
2. Tap the UP button until "DISP" is displayed.
3. Tap the UP button until "FLIP" is displayed.
4. Press ENTER, the display will show "ON/OFF".
5. Press the UP button to select "ON" to activate this function,
or "OFF" to deactivate this function.
6. Press ENTER to confirm.
7. Press MODE/ESC to return to the main menu.
SPEC MAIN MENU -
LAAU
With this function the lamp will ignite when power
is applied. By default the unit will automatically ingnite
when power is applied. Use this function to disable that
feature.
1. Access the main menu.
2. Tap the UP button until "SPEC" is displayed, press ENTER.
3. Tap the UP button until "LAAU" is displayed, press ENTER.
4. The display will show "ON/OFF". Press the UP button to
select "ON" to switch on the lamp, or "OFF" to switch off the
lamp.
American DJ - www.americandj.com - Accu Spot 250 II™ Instruction Manual Page 25
®
System Menu Accu Spot 250 II™
5. Press ENTER to confirm.
6. Press MODE/ESC to return to the main menu.
RDMX
address via any DMX controller. This function is factory set
to "ON" already.
1. Access the main menu by pressing MODE/ESC.
2. Tap the UP button until "SPEC" is displayed, press ENTER.
3. Tap the UP button until "RDNI I" is displayed, press ENTER.
4. The display will show "ON/OFF". Press the UP button to
select "ON" to activate this function, or "OFF" to deactivate.
5. Press ENTER to confirm, and "PASS" will flash quickly.
6. Press MODE/ESC to return to the main menu.
To use this function follow the instructions:
To adjust the address of your unit you must first go to the
address that it is currently set to using your DMX Contoller.
From there you can adjust the address, using your DMX Con-
toller. First make sure all channels are set to the value of "0".
1. On your DMX controller set the DMX value of Channel 1 to
the value "7".
2. Now set the DMX value of Channel 2 to the value "7" to
adjust the starting address between 1 and 255. To adjust the
address between 256 and 511 set Channel 2 to the value "8" .
3. Set the DMX value of Channel 3 to your desired start-
ing address. This will take about 20 seconds before the unit
accepts the new DMX address.
EXAMPLE: If you want the address to be 57, you must first set
the address that is currently assingned to the unit. The proceed
to set Channel 1s' value to "7", Channel 2s' value to "7", and
American DJ
With this function you are able to change the DMX
- www.americandj.com - Accu Spot 250 II™ Instruction Manual Page 26
®
System Menu